How to install Door / Window Magnetic Detector?
Posted: Thursday, January 06, 2011
by Coral Gong
Introduction
Door/window magnetic detector, also known as magnetic contact, is designed to protect doors, windows, sliding doors, sliding windows and cabinets and so on; widely used in wireless home or business security alarm system. It is divided into two parts: the sensor and the magnetic bar. When the sensor and the magnetic bar close together, the detector is ready for work. When the sensor is a certain distance away from the magnetic bar, the detector will immediately send out the alarming signal to notify the user.
1) First of all, the installing location should be cleaned up.
2) Mount the sensor on the fixed doorframe or window frame by double sided tape
3) Mount the magnetic bar on the edge of a moveable door or window by either double sided tape or screws.
4) If the surface of the frame is flat enough, double-sided foam tape is sufficient; otherwise, it is recommended to screw the mounting plate to the frame, then apply double sided tape.
Warning:
1) The distance of two parts should be less than 1-2 cm when the door or the window is closed.
2) Try to mount the detector as far away from the floor as possible to avoid damaging them. Mounting the sensors at a higher position will also result in better operating range.
3) Do not mount the detector to the exterior of the door or window, but always to the interior side to avoid being damaged or stolen by non-intended users.
More information on door / window magnetic detector please visit: www.alarmandaccessory.com
This Article has been viewed 372 times. (Not updated in real-time.)
No comments yet.We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.